Then turn the KEY to the RUN position and Press Page Forward to The flash of the PCM Turn the Key to the OFF position and disconnect theīCM. The BCM will need to be disconnected after the module When flashing a 2002 – 2004 LH vehicle the BCM may need to beĭisconnected if experiencing failures during the flash of the transmission The module can only be reprogrammed to a more Selected and programmed, the controller cannot be reprogrammed to aĭifferent calibration. A Diagnostic Trouble Code (DTC) will beĬAUTION: Extreme care must be taken when programming a calibration into a Will not operate the engine until it is programmed. Replacement ofįuture PCMs will require programming utilizing the DRBIII and TechCONNECT. Modules will no longer be pre-programmed when received from Mopar®. Mopar® is currently phasing out pre-programmed PCMs for the vehicles listed. I have flash DVD for the DRB III, hopefully I will get it and can then do programming on a “swap” system. Look here: Procedure in detail will be of interest to those contempating a PCM changeĪfter reading this, it is obvious that PCMs can be reprogrammed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |